ZWB2 filter 20,5 mm
How to change the clear lence to ZWB filter:
Unscrew the head: Remove the head of the flashlight to access the internal components.
Locate the pill: Inside the head, you'll find the pill, which screws into the head.
Unscrew the pill: Use a pair of fine-tipped needle nose pliers, tweezers, or another suitable tool to grip the slots on the pill and turn it counter-clockwise to unscrew it.
Remove the reflector and filter: Once the pill is unscrewed, tap gently to allow the reflector and filter to fall out. Be careful not to damage the LED or set the pill face down on it.
Discard the clear lens glass (if necessary): If your device came with an unfiltered light, you can dispose of the clear lens glass, as it may be unnecessary.
Install the ZWB2 filter: Place your new replacement ZWB2 filter, or cleaned filter if applicable, into the head of the device.
Reassemble the components: Drop the reflector back into place, ensuring both the filter and reflector sit flat in the front of the head. Then, screw the pill back into place securely. Make sure it is tightened adequately to ensure proper heat dissipation (refer to heating tips if provided).
